How to pull the water pipe video of the water well drilling rig

How do you pull a lost well pipe out of a drilled well?

the most effective tools we know about for pulling lost well pipes out of a drilled well are various versions of overshots. Overshots, an "overshoot" type tool, are a bit easier to get over the outside of a well pipe than spear type tools are to get into the well pipe, unless the upper end of the pipe is near the top of the well.

How do you retrieve piping from a well?

Spearing tools are used to retrieve piping from a well when it cannot be grasped with an external catch tool. Taps or Taper Taps are conical-shaped threaded devices used to retrieve pipes or tubing from a borehole by turning the tap into the open end of a pipe or tube dropped into the bore.

How do you drill a hole in a septic system?

Turn off the water and disconnect the water supply from the top of the drillpipe. Put the 1.25 inch well screen pipe into the 2.00 inch drill pipe and insert it all the way to the bottom of the hole. Pull the 2.00 inch drill pipe up and out of the ground, taking care not to pull the 1.25 inch well screen pipe up with it.

How does a well driller use a pipe grabber clamp?

You can see the clamp being used to secure the well pipe at the top of the casing while the well driller removes the upper length of well pipe that has just been lifted. Our second photo below illustrates the pipe grabber clamp used to grab the well pipe to keep it from falling back into the well during a pause in lifting to allow other tasks.

Can you slide a drop pipe into a well?

As I recall, in the December 2015 job my son-in-law was able to slide the first 60 feet of drop pipe into the well by this method. We stopped every 10 feet to tape the submersible cable to the drop pipe. And that, readers, is the story of a really old tool that still works.

How do you fix a broken well pipe?

With fresh glue inside the mating end of the coupling the retrieving well pipe section is pressed down onto the exposed top of the pipe that is already in the well. Wait for the glue to dry and try pulling out the whole assembly. If the broken-off plastic pipe is below water level, or badly damaged, this approach may have poor chances of success.